IB/ipath: Changes to support PIO bandwidth check on IBA7220

The IBA7220 uses a count-based triggering mechanism, and therefore
can't use the same bandwidth verification mechanism as older chips.

To support the 7220, allow enabling and disabling armlaunch errors on
application request.  Minor robustness improvements as well.

Signed-off-by: Dave Olson <dave.olson@qlogic.com>
Signed-off-by: Roland Dreier <rolandd@cisco.com>

1 files changed, 32 insertions, 0 deletions

diff --git a/drivers/infiniband/hw/ipath/ipath_driver.c b/drivers/infiniband/hw/ipath/ipath_driver.c
index bfcdf8c..d5ff6ca 100644
--- a/drivers/infiniband/hw/ipath/ipath_driver.c
+++ b/drivers/infiniband/hw/ipath/ipath_driver.c
@@ -334,6 +334,8 @@ static void ipath_verify_pioperf(struct ipath_devdata *dd)
 		udelay(1);
 	}
 
+	ipath_disable_armlaunch(dd);
+
 	writeq(0, piobuf); /* length 0, no dwords actually sent */
 	ipath_flush_wc();
 
@@ -365,6 +367,7 @@ static void ipath_verify_pioperf(struct ipath_devdata *dd)
 done:
 	/* disarm piobuf, so it's available again */
 	ipath_disarm_piobufs(dd, pbnum, 1);
+	ipath_enable_armlaunch(dd);
 }
 
 static int __devinit ipath_init_one(struct pci_dev *pdev,
@@ -2271,5 +2274,34 @@ int ipath_set_rx_pol_inv(struct ipath_devdata *dd, u8 new_pol_inv)
 	}
 	return 0;
 }
+
+/*
+ * Disable and enable the armlaunch error.  Used for PIO bandwidth testing on
+ * the 7220, which is count-based, rather than trigger-based.  Safe for the
+ * driver check, since it's at init.   Not completely safe when used for
+ * user-mode checking, since some error checking can be lost, but not
+ * particularly risky, and only has problematic side-effects in the face of
+ * very buggy user code.  There is no reference counting, but that's also
+ * fine, given the intended use.
+ */
+void ipath_enable_armlaunch(struct ipath_devdata *dd)
+{
+	dd->ipath_lasterror &= ~INFINIPATH_E_SPIOARMLAUNCH;
+	ipath_write_kreg(dd, dd->ipath_kregs->kr_errorclear,
+		INFINIPATH_E_SPIOARMLAUNCH);
+	dd->ipath_errormask |= INFINIPATH_E_SPIOARMLAUNCH;
+	ipath_write_kreg(dd, dd->ipath_kregs->kr_errormask,
+		dd->ipath_errormask);
+}
+
+void ipath_disable_armlaunch(struct ipath_devdata *dd)
+{
+	/* so don't re-enable if already set */
+	dd->ipath_maskederrs &= ~INFINIPATH_E_SPIOARMLAUNCH;
+	dd->ipath_errormask &= ~INFINIPATH_E_SPIOARMLAUNCH;
+	ipath_write_kreg(dd, dd->ipath_kregs->kr_errormask,
+		dd->ipath_errormask);
+}
+
 module_init(infinipath_init);
 module_exit(infinipath_cleanup);