diff options
| -rw-r--r-- | drivers/net/wireless/ath/ath9k/ar9003_phy.c | 186 | ||||
| -rw-r--r-- | drivers/net/wireless/ath/ath9k/ar9003_phy.h | 2 | ||||
| -rw-r--r-- | drivers/net/wireless/ath/ath9k/reg.h | 13 |
3 files changed, 198 insertions, 3 deletions
diff --git a/drivers/net/wireless/ath/ath9k/ar9003_phy.c b/drivers/net/wireless/ath/ath9k/ar9003_phy.c index 3e3472e..acbf122 100644 --- a/drivers/net/wireless/ath/ath9k/ar9003_phy.c +++ b/drivers/net/wireless/ath/ath9k/ar9003_phy.c @@ -186,7 +186,40 @@ static u32 ar9003_hw_compute_pll_control(struct ath_hw *ah, static void ar9003_hw_set_channel_regs(struct ath_hw *ah, struct ath9k_channel *chan) { - /* TODO */ + u32 phymode; + u32 enableDacFifo = 0; + + enableDacFifo = + (REG_READ(ah, AR_PHY_GEN_CTRL) & AR_PHY_GC_ENABLE_DAC_FIFO); + + /* Enable 11n HT, 20 MHz */ + phymode = AR_PHY_GC_HT_EN | AR_PHY_GC_SINGLE_HT_LTF1 | AR_PHY_GC_WALSH | + AR_PHY_GC_SHORT_GI_40 | enableDacFifo; + + /* Configure baseband for dynamic 20/40 operation */ + if (IS_CHAN_HT40(chan)) { + phymode |= AR_PHY_GC_DYN2040_EN; + /* Configure control (primary) channel at +-10MHz */ + if ((chan->chanmode == CHANNEL_A_HT40PLUS) || + (chan->chanmode == CHANNEL_G_HT40PLUS)) + phymode |= AR_PHY_GC_DYN2040_PRI_CH; + + } + + /* make sure we preserve INI settings */ + phymode |= REG_READ(ah, AR_PHY_GEN_CTRL); + /* turn off Green Field detection for STA for now */ + phymode &= ~AR_PHY_GC_GF_DETECT_EN; + + REG_WRITE(ah, AR_PHY_GEN_CTRL, phymode); + + /* Configure MAC for 20/40 operation */ + ath9k_hw_set11nmac2040(ah); + + /* global transmit timeout (25 TUs default)*/ + REG_WRITE(ah, AR_GTXTO, 25 << AR_GTXTO_TIMEOUT_LIMIT_S); + /* carrier sense timeout */ + REG_WRITE(ah, AR_CST, 0xF << AR_CST_TIMEOUT_LIMIT_S); } static void ar9003_hw_init_bb(struct ath_hw *ah, @@ -195,11 +228,158 @@ static void ar9003_hw_init_bb(struct ath_hw *ah, /* TODO */ } +void ar9003_hw_set_chain_masks(struct ath_hw *ah, u8 rx, u8 tx) +{ + switch (rx) { + case 0x5: + REG_SET_BIT(ah, AR_PHY_ANALOG_SWAP, + AR_PHY_SWAP_ALT_CHAIN); + case 0x3: + case 0x1: + case 0x2: + case 0x7: + REG_WRITE(ah, AR_PHY_RX_CHAINMASK, rx); + REG_WRITE(ah, AR_PHY_CAL_CHAINMASK, rx); + break; + default: + break; + } + + REG_WRITE(ah, AR_SELFGEN_MASK, tx); + if (tx == 0x5) { + REG_SET_BIT(ah, AR_PHY_ANALOG_SWAP, + AR_PHY_SWAP_ALT_CHAIN); + } +} + +/* + * Override INI values with chip specific configuration. + */ +static void ar9003_hw_override_ini(struct ath_hw *ah) +{ + u32 val; + + /* + * Set the RX_ABORT and RX_DIS and clear it only after + * RXE is set for MAC. This prevents frames with + * corrupted descriptor status. + */ + REG_SET_BIT(ah, AR_DIAG_SW, (AR_DIAG_RX_DIS | AR_DIAG_RX_ABORT)); + + /* + * For AR9280 and above, there is a new feature that allows + * Multicast search based on both MAC Address and Key ID. By default, + * this feature is enabled. But since the driver is not using this + * feature, we switch it off; otherwise multicast search based on + * MAC addr only will fail. + */ + val = REG_READ(ah, AR_PCU_MISC_MODE2) & (~AR_ADHOC_MCAST_KEYID_ENABLE); + REG_WRITE(ah, AR_PCU_MISC_MODE2, + val | AR_AGG_WEP_ENABLE_FIX | AR_AGG_WEP_ENABLE); +} + +static void ar9003_hw_prog_ini(struct ath_hw *ah, + struct ar5416IniArray *iniArr, + int column) +{ + unsigned int i, regWrites = 0; + + /* New INI format: Array may be undefined (pre, core, post arrays) */ + if (!iniArr->ia_array) + return; + + /* + * New INI format: Pre, core, and post arrays for a given subsystem + * may be modal (> 2 columns) or non-modal (2 columns). Determine if + * the array is non-modal and force the column to 1. + */ + if (column >= iniArr->ia_columns) + column = 1; + + for (i = 0; i < iniArr->ia_rows; i++) { + u32 reg = INI_RA(iniArr, i, 0); + u32 val = INI_RA(iniArr, i, column); + + REG_WRITE(ah, reg, val); + + /* + * Determine if this is a shift register value, and insert the + * configured delay if so. + */ + if (reg >= 0x16000 && reg < 0x17000 + && ah->config.analog_shiftreg) + udelay(100); + + DO_DELAY(regWrites); + } +} + static int ar9003_hw_process_ini(struct ath_hw *ah, struct ath9k_channel *chan) { - /* TODO */ - return -1; + struct ath_regulatory *regulatory = ath9k_hw_regulatory(ah); + unsigned int regWrites = 0, i; + struct ieee80211_channel *channel = chan->chan; + u32 modesIndex, freqIndex; + + switch (chan->chanmode) { + case CHANNEL_A: + case CHANNEL_A_HT20: + modesIndex = 1; + freqIndex = 1; + break; + case CHANNEL_A_HT40PLUS: + case CHANNEL_A_HT40MINUS: + modesIndex = 2; + freqIndex = 1; + break; + case CHANNEL_G: + case CHANNEL_G_HT20: + case CHANNEL_B: + modesIndex = 4; + freqIndex = 2; + break; + case CHANNEL_G_HT40PLUS: + case CHANNEL_G_HT40MINUS: + modesIndex = 3; + freqIndex = 2; + break; + + default: + return -EINVAL; + } + + for (i = 0; i < ATH_INI_NUM_SPLIT; i++) { + ar9003_hw_prog_ini(ah, &ah->iniSOC[i], modesIndex); + ar9003_hw_prog_ini(ah, &ah->iniMac[i], modesIndex); + ar9003_hw_prog_ini(ah, &ah->iniBB[i], modesIndex); + ar9003_hw_prog_ini(ah, &ah->iniRadio[i], modesIndex); + } + + REG_WRITE_ARRAY(&ah->iniModesRxGain, 1, regWrites); + REG_WRITE_ARRAY(&ah->iniModesTxGain, modesIndex, regWrites); + + /* + * For 5GHz channels requiring Fast Clock, apply + * different modal values. + */ + if (IS_CHAN_A_5MHZ_SPACED(chan)) + REG_WRITE_ARRAY(&ah->iniModesAdditional, + modesIndex, regWrites); + + ar9003_hw_override_ini(ah); + ar9003_hw_set_channel_regs(ah, chan); + ar9003_hw_set_chain_masks(ah, ah->rxchainmask, ah->txchainmask); + + /* Set TX power */ + ah->eep_ops->set_txpower(ah, chan, + ath9k_regd_get_ctl(regulatory, chan), + channel->max_antenna_gain * 2, + channel->max_power * 2, + min((u32) MAX_RATE_POWER, + (u32) regulatory->power_limit)); + + return 0; } static void ar9003_hw_set_rfmode(struct ath_hw *ah, diff --git a/drivers/net/wireless/ath/ath9k/ar9003_phy.h b/drivers/net/wireless/ath/ath9k/ar9003_phy.h index 2e51e57..70e647b 100644 --- a/drivers/net/wireless/ath/ath9k/ar9003_phy.h +++ b/drivers/net/wireless/ath/ath9k/ar9003_phy.h @@ -801,4 +801,6 @@ #define AR_PHY_BB_WD_STATUS_CLR 0x00000008 +void ar9003_hw_set_chain_masks(struct ath_hw *ah, u8 rx, u8 tx); + #endif /* AR9003_PHY_H */ diff --git a/drivers/net/wireless/ath/ath9k/reg.h b/drivers/net/wireless/ath/ath9k/reg.h index 9d63286..96b2cfe 100644 --- a/drivers/net/wireless/ath/ath9k/reg.h +++ b/drivers/net/wireless/ath/ath9k/reg.h @@ -1756,4 +1756,17 @@ enum { #define AR9271_CORE_CLOCK 117 /* clock to 117Mhz */ #define AR9271_TARGET_BAUD_RATE 19200 /* 115200 */ +#define AR_AGG_WEP_ENABLE_FIX 0x00000008 /* This allows the use of AR_AGG_WEP_ENABLE */ +#define AR_ADHOC_MCAST_KEYID_ENABLE 0x00000040 /* This bit enables the Multicast search + * based on both MAC Address and Key ID. + * If bit is 0, then Multicast search is + * based on MAC address only. + * For Merlin and above only. + */ +#define AR_AGG_WEP_ENABLE 0x00020000 /* This field enables AGG_WEP feature, + * when it is enable, AGG_WEP would takes + * charge of the encryption interface of + * pcu_txsm. + */ + #endif |