diff options
| -rw-r--r-- | arch/mips/alchemy/common/platform.c | 15 | ||||
| -rw-r--r-- | arch/mips/include/asm/mach-au1x00/au1xxx_eth.h | 1 | ||||
| -rw-r--r-- | drivers/net/au1000_eth.c | 31 |
3 files changed, 22 insertions, 25 deletions
diff --git a/arch/mips/alchemy/common/platform.c b/arch/mips/alchemy/common/platform.c index c233d64..1dc55ee 100644 --- a/arch/mips/alchemy/common/platform.c +++ b/arch/mips/alchemy/common/platform.c @@ -12,6 +12,7 @@ */ #include <linux/dma-mapping.h> +#include <linux/etherdevice.h> #include <linux/platform_device.h> #include <linux/serial_8250.h> #include <linux/init.h> @@ -21,6 +22,8 @@ #include <asm/mach-au1x00/au1100_mmc.h> #include <asm/mach-au1x00/au1xxx_eth.h> +#include <prom.h> + #define PORT(_base, _irq) \ { \ .mapbase = _base, \ @@ -434,17 +437,27 @@ static int __init au1xxx_platform_init(void) { unsigned int uartclk = get_au1x00_uart_baud_base() * 16; int err, i; + unsigned char ethaddr[6]; /* Fill up uartclk. */ for (i = 0; au1x00_uart_data[i].flags; i++) au1x00_uart_data[i].uartclk = uartclk; + /* use firmware-provided mac addr if available and necessary */ + i = prom_get_ethernet_addr(ethaddr); + if (!i && !is_valid_ether_addr(au1xxx_eth0_platform_data.mac)) + memcpy(au1xxx_eth0_platform_data.mac, ethaddr, 6); + err = platform_add_devices(au1xxx_platform_devices, ARRAY_SIZE(au1xxx_platform_devices)); #ifndef CONFIG_SOC_AU1100 + ethaddr[5] += 1; /* next addr for 2nd MAC */ + if (!i && !is_valid_ether_addr(au1xxx_eth1_platform_data.mac)) + memcpy(au1xxx_eth1_platform_data.mac, ethaddr, 6); + /* Register second MAC if enabled in pinfunc */ if (!err && !(au_readl(SYS_PINFUNC) & (u32)SYS_PF_NI2)) - platform_device_register(&au1xxx_eth1_device); + err = platform_device_register(&au1xxx_eth1_device); #endif return err; diff --git a/arch/mips/include/asm/mach-au1x00/au1xxx_eth.h b/arch/mips/include/asm/mach-au1x00/au1xxx_eth.h index bae9b75..49dc8d9 100644 --- a/arch/mips/include/asm/mach-au1x00/au1xxx_eth.h +++ b/arch/mips/include/asm/mach-au1x00/au1xxx_eth.h @@ -9,6 +9,7 @@ struct au1000_eth_platform_data { int phy_addr; int phy_busid; int phy_irq; + char mac[6]; }; void __init au1xxx_override_eth_cfg(unsigned port, diff --git a/drivers/net/au1000_eth.c b/drivers/net/au1000_eth.c index ece6128..17e7e27 100644 --- a/drivers/net/au1000_eth.c +++ b/drivers/net/au1000_eth.c @@ -104,14 +104,6 @@ MODULE_VERSION(DRV_VERSION); * complete immediately. */ -/* These addresses are only used if yamon doesn't tell us what - * the mac address is, and the mac address is not passed on the - * command line. - */ -static unsigned char au1000_mac_addr[6] __devinitdata = { - 0x00, 0x50, 0xc2, 0x0c, 0x30, 0x00 -}; - struct au1000_private *au_macs[NUM_ETH_INTERFACES]; /* @@ -1002,7 +994,6 @@ static int __devinit au1000_probe(struct platform_device *pdev) db_dest_t *pDB, *pDBfree; int irq, i, err = 0; struct resource *base, *macen; - char ethaddr[6]; base = platform_get_resource(pdev, IORESOURCE_MEM, 0); if (!base) { @@ -1079,24 +1070,13 @@ static int __devinit au1000_probe(struct platform_device *pdev) } aup->mac_id = pdev->id; - if (pdev->id == 0) { - if (prom_get_ethernet_addr(ethaddr) == 0) - memcpy(au1000_mac_addr, ethaddr, sizeof(au1000_mac_addr)); - else { - netdev_info(dev, "No MAC address found\n"); - /* Use the hard coded MAC addresses */ - } - + if (pdev->id == 0) au1000_setup_hw_rings(aup, MAC0_RX_DMA_ADDR, MAC0_TX_DMA_ADDR); - } else if (pdev->id == 1) + else if (pdev->id == 1) au1000_setup_hw_rings(aup, MAC1_RX_DMA_ADDR, MAC1_TX_DMA_ADDR); - /* - * Assign to the Ethernet ports two consecutive MAC addresses - * to match those that are printed on their stickers - */ - memcpy(dev->dev_addr, au1000_mac_addr, sizeof(au1000_mac_addr)); - dev->dev_addr[5] += pdev->id; + /* set a random MAC now in case platform_data doesn't provide one */ + random_ether_addr(dev->dev_addr); *aup->enable = 0; aup->mac_enabled = 0; @@ -1106,6 +1086,9 @@ static int __devinit au1000_probe(struct platform_device *pdev) dev_info(&pdev->dev, "no platform_data passed, PHY search on MAC0\n"); aup->phy1_search_mac0 = 1; } else { + if (is_valid_ether_addr(pd->mac)) + memcpy(dev->dev_addr, pd->mac, 6); + aup->phy_static_config = pd->phy_static_config; aup->phy_search_highest_addr = pd->phy_search_highest_addr; aup->phy1_search_mac0 = pd->phy1_search_mac0; |