diff options
Diffstat (limited to 'arch/arm/mach-davinci/board-da850-evm.c')
| -rw-r--r-- | arch/arm/mach-davinci/board-da850-evm.c | 126 |
1 files changed, 124 insertions, 2 deletions
diff --git a/arch/arm/mach-davinci/board-da850-evm.c b/arch/arm/mach-davinci/board-da850-evm.c index f893617..6659a90 100644 --- a/arch/arm/mach-davinci/board-da850-evm.c +++ b/arch/arm/mach-davinci/board-da850-evm.c @@ -31,6 +31,8 @@ #include <linux/input/tps6507x-ts.h> #include <linux/spi/spi.h> #include <linux/spi/flash.h> +#include <linux/delay.h> +#include <linux/wl12xx.h> #include <asm/mach-types.h> #include <asm/mach/arch.h> @@ -49,6 +51,9 @@ #define DA850_MMCSD_CD_PIN GPIO_TO_PIN(4, 0) #define DA850_MMCSD_WP_PIN GPIO_TO_PIN(4, 1) +#define DA850_WLAN_EN GPIO_TO_PIN(6, 9) +#define DA850_WLAN_IRQ GPIO_TO_PIN(6, 10) + #define DA850_MII_MDIO_CLKEN_PIN GPIO_TO_PIN(2, 6) static struct mtd_partition da850evm_spiflash_part[] = { @@ -251,7 +256,7 @@ static struct davinci_nand_pdata da850_evm_nandflash_data = { .nr_parts = ARRAY_SIZE(da850_evm_nandflash_partition), .ecc_mode = NAND_ECC_HW, .ecc_bits = 4, - .options = NAND_USE_FLASH_BBT, + .bbt_options = NAND_BBT_USE_FLASH, .timing = &da850_evm_nandflash_timing, }; @@ -1143,6 +1148,112 @@ static __init int da850_evm_init_cpufreq(void) static __init int da850_evm_init_cpufreq(void) { return 0; } #endif +#ifdef CONFIG_DA850_WL12XX + +static void wl12xx_set_power(int index, bool power_on) +{ + static bool power_state; + + pr_debug("Powering %s wl12xx", power_on ? "on" : "off"); + + if (power_on == power_state) + return; + power_state = power_on; + + if (power_on) { + /* Power up sequence required for wl127x devices */ + gpio_set_value(DA850_WLAN_EN, 1); + usleep_range(15000, 15000); + gpio_set_value(DA850_WLAN_EN, 0); + usleep_range(1000, 1000); + gpio_set_value(DA850_WLAN_EN, 1); + msleep(70); + } else { + gpio_set_value(DA850_WLAN_EN, 0); + } +} + +static struct davinci_mmc_config da850_wl12xx_mmc_config = { + .set_power = wl12xx_set_power, + .wires = 4, + .max_freq = 25000000, + .caps = MMC_CAP_4_BIT_DATA | MMC_CAP_NONREMOVABLE | + MMC_CAP_POWER_OFF_CARD, + .version = MMC_CTLR_VERSION_2, +}; + +static const short da850_wl12xx_pins[] __initconst = { + DA850_MMCSD1_DAT_0, DA850_MMCSD1_DAT_1, DA850_MMCSD1_DAT_2, + DA850_MMCSD1_DAT_3, DA850_MMCSD1_CLK, DA850_MMCSD1_CMD, + DA850_GPIO6_9, DA850_GPIO6_10, + -1 +}; + +static struct wl12xx_platform_data da850_wl12xx_wlan_data __initdata = { + .irq = -1, + .board_ref_clock = WL12XX_REFCLOCK_38, + .platform_quirks = WL12XX_PLATFORM_QUIRK_EDGE_IRQ, +}; + +static __init int da850_wl12xx_init(void) +{ + int ret; + + ret = davinci_cfg_reg_list(da850_wl12xx_pins); + if (ret) { + pr_err("wl12xx/mmc mux setup failed: %d\n", ret); + goto exit; + } + + ret = da850_register_mmcsd1(&da850_wl12xx_mmc_config); + if (ret) { + pr_err("wl12xx/mmc registration failed: %d\n", ret); + goto exit; + } + + ret = gpio_request_one(DA850_WLAN_EN, GPIOF_OUT_INIT_LOW, "wl12xx_en"); + if (ret) { + pr_err("Could not request wl12xx enable gpio: %d\n", ret); + goto exit; + } + + ret = gpio_request_one(DA850_WLAN_IRQ, GPIOF_IN, "wl12xx_irq"); + if (ret) { + pr_err("Could not request wl12xx irq gpio: %d\n", ret); + goto free_wlan_en; + } + + da850_wl12xx_wlan_data.irq = gpio_to_irq(DA850_WLAN_IRQ); + + ret = wl12xx_set_platform_data(&da850_wl12xx_wlan_data); + if (ret) { + pr_err("Could not set wl12xx data: %d\n", ret); + goto free_wlan_irq; + } + + return 0; + +free_wlan_irq: + gpio_free(DA850_WLAN_IRQ); + +free_wlan_en: + gpio_free(DA850_WLAN_EN); + +exit: + return ret; +} + +#else /* CONFIG_DA850_WL12XX */ + +static __init int da850_wl12xx_init(void) +{ + return 0; +} + +#endif /* CONFIG_DA850_WL12XX */ + +#define DA850EVM_SATA_REFCLKPN_RATE (100 * 1000 * 1000) + static __init void da850_evm_init(void) { int ret; @@ -1195,6 +1306,11 @@ static __init void da850_evm_init(void) if (ret) pr_warning("da850_evm_init: mmcsd0 registration failed:" " %d\n", ret); + + ret = da850_wl12xx_init(); + if (ret) + pr_warning("da850_evm_init: wl12xx initialization" + " failed: %d\n", ret); } davinci_serial_init(&da850_evm_uart_config); @@ -1264,6 +1380,11 @@ static __init void da850_evm_init(void) pr_warning("da850_evm_init: spi 1 registration failed: %d\n", ret); + ret = da850_register_sata(DA850EVM_SATA_REFCLKPN_RATE); + if (ret) + pr_warning("da850_evm_init: sata registration failed: %d\n", + ret); + da850_evm_setup_mac_addr(); } @@ -1284,9 +1405,10 @@ static void __init da850_evm_map_io(void) } MACHINE_START(DAVINCI_DA850_EVM, "DaVinci DA850/OMAP-L138/AM18x EVM") - .boot_params = (DA8XX_DDR_BASE + 0x100), + .atag_offset = 0x100, .map_io = da850_evm_map_io, .init_irq = cp_intc_init, .timer = &davinci_timer, .init_machine = da850_evm_init, + .dma_zone_size = SZ_128M, MACHINE_END |