diff options
Diffstat (limited to 'drivers/input/touchscreen/mms152_download.h')
| -rw-r--r-- | drivers/input/touchscreen/mms152_download.h | 183 |
1 files changed, 0 insertions, 183 deletions
diff --git a/drivers/input/touchscreen/mms152_download.h b/drivers/input/touchscreen/mms152_download.h deleted file mode 100644 index 275507c..0000000 --- a/drivers/input/touchscreen/mms152_download.h +++ /dev/null @@ -1,183 +0,0 @@ -/*-------------------------------------------------------- -// -// -// Melfas MCS7000 Series Download base v1.0 2010.04.05 -// -// -//------------------------------------------------------*/ - - -#ifndef __MELFAS_FIRMWARE_DOWNLOAD_H__ -#define __MELFAS_FIRMWARE_DOWNLOAD_H__ - -#include <linux/regulator/consumer.h> - - -/*================================================= -// -// MELFAS Firmware download pharameters -// -//================================================*/ - -#define MELFAS_TRANSFER_LENGTH (32/8) -#define MELFAS_FIRMWARE_MAX_SIZE (32*1024) - -/* 0 : 1Chip Download, 1: 2Chip Download */ -#define MELFAS_2CHIP_DOWNLOAD_ENABLE 0 - -/*---------------------------------------------------- -// ISP Mode -//--------------------------------------------------*/ -#define ISP_MODE_ERASE_FLASH 0x01 -#define ISP_MODE_SERIAL_WRITE 0x02 -#define ISP_MODE_SERIAL_READ 0x03 -#define ISP_MODE_NEXT_CHIP_BYPASS 0x04 - -/*---------------------------------------------------- -// ISP Mode -//--------------------------------------------------*/ -/* 0 : 1Chip Download, 1: 2Chip Download */ -#define MELFAS_ISC_2CHIP_DOWNLOAD_ENABLE 0 -/* 0 : disable, 1: enable */ -#define MELFAS_CORE_FIRWMARE_UPDATE_ENABLE 1 -/* 0 : disable, 1: enable */ -#define MELFAS_PRIVATE_CONFIGURATION_UPDATE_ENABLE 1 -/* 0 : disable, 1: enable */ -#define MELFAS_PUBLIC_CONFIGURATION_UPDATE_ENABLE 1 - -#define MELFAS_CRC_CHECK_ENABLE 1 - -#define ISC_MODE_SLAVE_ADDRESS 0x48 - -/* 0 : USE ISC_PRIVATE_CONFIG_FLASH_START 1: READ FROM RMI MAP(0x61,0x62) */ -#define ISC_READ_DOWNLOAD_POSITION 1 -#define ISC_PRIVATE_CONFIG_FLASH_START 26 -#define ISC_PUBLIC_CONFIG_FLASH_START 28 - -/* address for ISC MODE */ -#define ISC_DOWNLOAD_MODE_ENTER 0x5F -#define ISC_DOWNLOAD_MODE 0x60 -#define ISC_PRIVATE_CONFIGURATION_START_ADDR 0x61 -#define ISC_PUBLIC_CONFIGURATION_START_ADDR 0x62 - -/* return value from slave */ -#define ISC_READ_SLAVE_CRC_OK 0x63 - -/* mode */ -#define ISC_CORE_FIRMWARE_DL_MODE 0x01 -#define ISC_PRIVATE_CONFIGURATION_DL_MODE 0x02 -#define ISC_PUBLIC_CONFIGURATION_DL_MODE 0x03 -#define ISC_SLAVE_DOWNLOAD_START 0x04 - - -/*---------------------------------------------------- -// Return values of download function -//-------------------------------------------------- */ -#define MCSDL_RET_SUCCESS 0x00 -#define MCSDL_RET_ERASE_FLASH_VERIFY_FAILED 0x01 -#define MCSDL_RET_PROGRAM_VERIFY_FAILED 0x02 -#define MCSDL_FIRMWARE_UPDATE_MODE_ENTER_FAILED 0x03 -#define MCSDL_FIRMWARE_UPDATE_FAILED 0x04 -#define MCSDL_LEAVE_FIRMWARE_UPDATE_MODE_FAILED 0x05 - -#define MCSDL_RET_PROGRAM_SIZE_IS_WRONG 0x10 -#define MCSDL_RET_VERIFY_SIZE_IS_WRONG 0x11 -#define MCSDL_RET_WRONG_BINARY 0x12 - -#define MCSDL_RET_READING_HEXFILE_FAILED 0x21 -#define MCSDL_RET_FILE_ACCESS_FAILED 0x22 -#define MCSDL_RET_MELLOC_FAILED 0x23 - -#define MCSDL_RET_ISC_SLAVE_CRC_CHECK_FAILED 0x30 -#define MCSDL_RET_ISC_SLAVE_DOWNLOAD_TIME_OVER 0x31 - -#define MCSDL_RET_WRONG_MODULE_REVISION 0x40 - - -/*---------------------------------------------------- -// When you can't control VDD nor CE. -// Set this value 1 -// Then Melfas Chip can prepare chip reset. -//-------------------------------------------------- */ - -/* If 'enable download command' is needed ( Pinmap dependent option ). */ -#define MELFAS_USE_PROTOCOL_COMMAND_FOR_DOWNLOAD 0 - -/*============================================================ -// -// Port setting. ( Melfas preset this value. ) -// -//========================================================== */ - -/* If want to set Enable : Set to 1 */ - -#define MCSDL_USE_CE_CONTROL 0 -#define MCSDL_USE_VDD_CONTROL 1 -#define MCSDL_USE_RESETB_CONTROL 1 - -void mcsdl_vdd_on(void); -void mcsdl_vdd_off(void); - -#define GPIO_TOUCH_INT 38 -#define GPIO_I2C0_SCL 130 -#define GPIO_I2C0_SDA 131 - - -/* Touch Screen Interface Specification Multi Touch (V0.5) */ - -/* REGISTERS */ -#define MCSTS_STATUS_REG 0x00 /* Status */ -#define MCSTS_MODE_CONTROL_REG 0x01 /* Mode Control */ -#define MCSTS_RESOL_HIGH_REG 0x02 /* Resolution(High Byte) */ -#define MCSTS_RESOL_X_LOW_REG 0x08 /* Resolution(X Low Byte) */ -#define MCSTS_RESOL_Y_LOW_REG 0x0a /* Resolution(Y Low Byte) */ -#define MCSTS_INPUT_INFO_REG 0x10 /* Input Information */ -#define MCSTS_POINT_HIGH_REG 0x11 /* Point(High Byte) */ -#define MCSTS_POINT_X_LOW_REG 0x12 /* Point(X Low Byte) */ -#define MCSTS_POINT_Y_LOW_REG 0x13 /* Point(Y Low Byte) */ -#define MCSTS_WIDTH_REG 0x14 /* Width */ -#define MCSTS_STRENGTH_REG 0x15 /* Strength */ -#define MCSTS_MODULE_VER_REG 0x30 /* H/W Module Revision */ -#define MCSTS_FIRMWARE_VER_REG 0x31 /* F/W Version */ - - -/*============================================================ -// -// Porting factors for Baseband -// -//========================================================== */ - -#include "mms152_download_porting.h" - - -/*---------------------------------------------------- -// Functions -//-------------------------------------------------- */ - -int mcsdl_download_binary_data(int); /* with binary type .c file. */ -int mcsdl_download_binary_data_verify(int); -int mcsdl_download_binary_file(void); /* with binary type .bin file. */ - -int mms100_ISC_download_binary_data(int, INT8); -int mms100_ISC_download_binary_file(void); - -/*--------------------------------- -// Delay functions -//------------------------------- */ -void mcsdl_delay(UINT32 nCount); - -#if MELFAS_ENABLE_DELAY_TEST /* For initial porting test. */ -void mcsdl_delay_test(INT32 nCount); -#endif - -#endif - -extern const UINT16 MELFAS_binary_nLength_1; -extern const UINT8 MELFAS_binary_1[]; -extern const UINT16 MELFAS_binary_nLength_2; -extern const UINT8 MELFAS_binary_2[]; -extern const UINT16 MELFAS_binary_nLength_3; -extern const UINT8 MELFAS_binary_3[]; -extern const UINT16 MELFAS_binary_nLength_4; -extern const UINT8 MELFAS_binary_4[]; - |