diff options
Diffstat (limited to 'drivers/net/tulip/interrupt.c')
-rw-r--r-- | drivers/net/tulip/interrupt.c | 126 |
1 files changed, 63 insertions, 63 deletions
diff --git a/drivers/net/tulip/interrupt.c b/drivers/net/tulip/interrupt.c index bb35581..da4f759 100644 --- a/drivers/net/tulip/interrupt.c +++ b/drivers/net/tulip/interrupt.c @@ -139,22 +139,22 @@ int tulip_poll(struct net_device *dev, int *budget) } /* Acknowledge current RX interrupt sources. */ iowrite32((RxIntr | RxNoBuf), tp->base_addr + CSR5); - - + + /* If we own the next entry, it is a new packet. Send it up. */ while ( ! (tp->rx_ring[entry].status & cpu_to_le32(DescOwned))) { s32 status = le32_to_cpu(tp->rx_ring[entry].status); - - + + if (tp->dirty_rx + RX_RING_SIZE == tp->cur_rx) break; - + if (tulip_debug > 5) printk(KERN_DEBUG "%s: In tulip_rx(), entry %d %8.8x.\n", dev->name, entry, status); if (--rx_work_limit < 0) goto not_done; - + if ((status & 0x38008300) != 0x0300) { if ((status & 0x38000300) != 0x0300) { /* Ingore earlier buffers. */ @@ -180,7 +180,7 @@ int tulip_poll(struct net_device *dev, int *budget) /* Omit the four octet CRC from the length. */ short pkt_len = ((status >> 16) & 0x7ff) - 4; struct sk_buff *skb; - + #ifndef final_version if (pkt_len > 1518) { printk(KERN_WARNING "%s: Bogus packet size of %d (%#x).\n", @@ -213,7 +213,7 @@ int tulip_poll(struct net_device *dev, int *budget) } else { /* Pass up the skb already on the Rx ring. */ char *temp = skb_put(skb = tp->rx_buffers[entry].skb, pkt_len); - + #ifndef final_version if (tp->rx_buffers[entry].mapping != le32_to_cpu(tp->rx_ring[entry].buffer1)) { @@ -225,17 +225,17 @@ int tulip_poll(struct net_device *dev, int *budget) skb->head, temp); } #endif - + pci_unmap_single(tp->pdev, tp->rx_buffers[entry].mapping, PKT_BUF_SZ, PCI_DMA_FROMDEVICE); - + tp->rx_buffers[entry].skb = NULL; tp->rx_buffers[entry].mapping = 0; } skb->protocol = eth_type_trans(skb, dev); - + netif_receive_skb(skb); - + dev->last_rx = jiffies; tp->stats.rx_packets++; tp->stats.rx_bytes += pkt_len; @@ -245,12 +245,12 @@ int tulip_poll(struct net_device *dev, int *budget) entry = (++tp->cur_rx) % RX_RING_SIZE; if (tp->cur_rx - tp->dirty_rx > RX_RING_SIZE/4) tulip_refill_rx(dev); - + } - + /* New ack strategy... irq does not ack Rx any longer hopefully this helps */ - + /* Really bad things can happen here... If new packet arrives * and an irq arrives (tx or just due to occasionally unset * mask), it will be acked by irq handler, but new thread @@ -259,28 +259,28 @@ int tulip_poll(struct net_device *dev, int *budget) * tomorrow (night 011029). If it will not fail, we won * finally: amount of IO did not increase at all. */ } while ((ioread32(tp->base_addr + CSR5) & RxIntr)); - + done: - + #ifdef CONFIG_TULIP_NAPI_HW_MITIGATION - + /* We use this simplistic scheme for IM. It's proven by real life installations. We can have IM enabled - continuesly but this would cause unnecessary latency. - Unfortunely we can't use all the NET_RX_* feedback here. - This would turn on IM for devices that is not contributing - to backlog congestion with unnecessary latency. - + continuesly but this would cause unnecessary latency. + Unfortunely we can't use all the NET_RX_* feedback here. + This would turn on IM for devices that is not contributing + to backlog congestion with unnecessary latency. + We monitor the the device RX-ring and have: - + HW Interrupt Mitigation either ON or OFF. - - ON: More then 1 pkt received (per intr.) OR we are dropping + + ON: More then 1 pkt received (per intr.) OR we are dropping OFF: Only 1 pkt received - + Note. We only use min and max (0, 15) settings from mit_table */ - - + + if( tp->flags & HAS_INTR_MITIGATION) { if( received > 1 ) { if( ! tp->mit_on ) { @@ -297,20 +297,20 @@ done: } #endif /* CONFIG_TULIP_NAPI_HW_MITIGATION */ - + dev->quota -= received; *budget -= received; - + tulip_refill_rx(dev); - + /* If RX ring is not full we are out of memory. */ if (tp->rx_buffers[tp->dirty_rx % RX_RING_SIZE].skb == NULL) goto oom; - + /* Remove us from polling list and enable RX intr. */ - + netif_rx_complete(dev); iowrite32(tulip_tbl[tp->chip_id].valid_intrs, tp->base_addr+CSR7); - + /* The last op happens after poll completion. Which means the following: * 1. it can race with disabling irqs in irq handler * 2. it can race with dise/enabling irqs in other poll threads @@ -321,9 +321,9 @@ done: * due to races in masking and due to too late acking of already * processed irqs. But it must not result in losing events. */ - + return 0; - + not_done: if (!received) { @@ -331,29 +331,29 @@ done: } dev->quota -= received; *budget -= received; - + if (tp->cur_rx - tp->dirty_rx > RX_RING_SIZE/2 || tp->rx_buffers[tp->dirty_rx % RX_RING_SIZE].skb == NULL) tulip_refill_rx(dev); - + if (tp->rx_buffers[tp->dirty_rx % RX_RING_SIZE].skb == NULL) goto oom; - + return 1; - - + + oom: /* Executed with RX ints disabled */ - - + + /* Start timer, stop polling, but do not enable rx interrupts. */ mod_timer(&tp->oom_timer, jiffies+1); - + /* Think: timer_pending() was an explicit signature of bug. * Timer can be pending now but fired and completed * before we did netif_rx_complete(). See? We would lose it. */ - + /* remove ourselves from the polling list */ netif_rx_complete(dev); - + return 0; } @@ -521,9 +521,9 @@ irqreturn_t tulip_interrupt(int irq, void *dev_instance, struct pt_regs *regs) /* Let's see whether the interrupt really is for us */ csr5 = ioread32(ioaddr + CSR5); - if (tp->flags & HAS_PHY_IRQ) + if (tp->flags & HAS_PHY_IRQ) handled = phy_interrupt (dev); - + if ((csr5 & (NormalIntr|AbnormalIntr)) == 0) return IRQ_RETVAL(handled); @@ -538,17 +538,17 @@ irqreturn_t tulip_interrupt(int irq, void *dev_instance, struct pt_regs *regs) /* Mask RX intrs and add the device to poll list. */ iowrite32(tulip_tbl[tp->chip_id].valid_intrs&~RxPollInt, ioaddr + CSR7); netif_rx_schedule(dev); - + if (!(csr5&~(AbnormalIntr|NormalIntr|RxPollInt|TPLnkPass))) break; } - + /* Acknowledge the interrupt sources we handle here ASAP the poll function does Rx and RxNoBuf acking */ - + iowrite32(csr5 & 0x0001ff3f, ioaddr + CSR5); -#else +#else /* Acknowledge all of the current interrupt sources ASAP. */ iowrite32(csr5 & 0x0001ffff, ioaddr + CSR5); @@ -559,11 +559,11 @@ irqreturn_t tulip_interrupt(int irq, void *dev_instance, struct pt_regs *regs) } #endif /* CONFIG_TULIP_NAPI */ - + if (tulip_debug > 4) printk(KERN_DEBUG "%s: interrupt csr5=%#8.8x new csr5=%#8.8x.\n", dev->name, csr5, ioread32(ioaddr + CSR5)); - + if (csr5 & (TxNoBuf | TxDied | TxIntr | TimerInt)) { unsigned int dirty_tx; @@ -737,17 +737,17 @@ irqreturn_t tulip_interrupt(int irq, void *dev_instance, struct pt_regs *regs) #ifdef CONFIG_TULIP_NAPI if (rxd) csr5 &= ~RxPollInt; - } while ((csr5 & (TxNoBuf | - TxDied | - TxIntr | + } while ((csr5 & (TxNoBuf | + TxDied | + TxIntr | TimerInt | /* Abnormal intr. */ - RxDied | - TxFIFOUnderflow | - TxJabber | - TPLnkFail | + RxDied | + TxFIFOUnderflow | + TxJabber | + TPLnkFail | SytemError )) != 0); -#else +#else } while ((csr5 & (NormalIntr|AbnormalIntr)) != 0); tulip_refill_rx(dev); |