diff options
Diffstat (limited to 'drivers/net/wireless/wl12xx/conf.h')
| -rw-r--r-- | drivers/net/wireless/wl12xx/conf.h | 125 |
1 files changed, 114 insertions, 11 deletions
diff --git a/drivers/net/wireless/wl12xx/conf.h b/drivers/net/wireless/wl12xx/conf.h index a16b361..856a8a2 100644 --- a/drivers/net/wireless/wl12xx/conf.h +++ b/drivers/net/wireless/wl12xx/conf.h @@ -496,6 +496,26 @@ struct conf_rx_settings { CONF_HW_BIT_RATE_2MBPS) #define CONF_TX_RATE_RETRY_LIMIT 10 +/* + * Rates supported for data packets when operating as AP. Note the absense + * of the 22Mbps rate. There is a FW limitation on 12 rates so we must drop + * one. The rate dropped is not mandatory under any operating mode. + */ +#define CONF_TX_AP_ENABLED_RATES (CONF_HW_BIT_RATE_1MBPS | \ + CONF_HW_BIT_RATE_2MBPS | CONF_HW_BIT_RATE_5_5MBPS | \ + CONF_HW_BIT_RATE_6MBPS | CONF_HW_BIT_RATE_9MBPS | \ + CONF_HW_BIT_RATE_11MBPS | CONF_HW_BIT_RATE_12MBPS | \ + CONF_HW_BIT_RATE_18MBPS | CONF_HW_BIT_RATE_24MBPS | \ + CONF_HW_BIT_RATE_36MBPS | CONF_HW_BIT_RATE_48MBPS | \ + CONF_HW_BIT_RATE_54MBPS) + +/* + * Default rates for management traffic when operating in AP mode. This + * should be configured according to the basic rate set of the AP + */ +#define CONF_TX_AP_DEFAULT_MGMT_RATES (CONF_HW_BIT_RATE_1MBPS | \ + CONF_HW_BIT_RATE_2MBPS | CONF_HW_BIT_RATE_5_5MBPS) + struct conf_tx_rate_class { /* @@ -636,9 +656,9 @@ struct conf_tx_settings { /* * Configuration for rate classes for TX (currently only one - * rate class supported.) + * rate class supported). Used in non-AP mode. */ - struct conf_tx_rate_class rc_conf; + struct conf_tx_rate_class sta_rc_conf; /* * Configuration for access categories for TX rate control. @@ -647,6 +667,28 @@ struct conf_tx_settings { struct conf_tx_ac_category ac_conf[CONF_TX_MAX_AC_COUNT]; /* + * Configuration for rate classes in AP-mode. These rate classes + * are for the AC TX queues + */ + struct conf_tx_rate_class ap_rc_conf[CONF_TX_MAX_AC_COUNT]; + + /* + * Management TX rate class for AP-mode. + */ + struct conf_tx_rate_class ap_mgmt_conf; + + /* + * Broadcast TX rate class for AP-mode. + */ + struct conf_tx_rate_class ap_bcst_conf; + + /* + * AP-mode - allow this number of TX retries to a station before an + * event is triggered from FW. + */ + u16 ap_max_tx_retries; + + /* * Configuration for TID parameters. */ u8 tid_conf_count; @@ -687,6 +729,12 @@ struct conf_tx_settings { * Range: CONF_HW_BIT_RATE_* bit mask */ u32 basic_rate_5; + + /* + * TX retry limits for templates + */ + u8 tmpl_short_retry_limit; + u8 tmpl_long_retry_limit; }; enum { @@ -912,6 +960,14 @@ struct conf_conn_settings { u8 psm_entry_retries; /* + * Specifies the maximum number of times to try PSM exit if it fails + * (if sending the appropriate null-func message fails.) + * + * Range 0 - 255 + */ + u8 psm_exit_retries; + + /* * Specifies the maximum number of times to try transmit the PSM entry * null-func frame for each PSM entry attempt * @@ -1036,30 +1092,30 @@ struct conf_scan_settings { /* * The minimum time to wait on each channel for active scans * - * Range: 0 - 65536 tu + * Range: u32 tu/1000 */ - u16 min_dwell_time_active; + u32 min_dwell_time_active; /* * The maximum time to wait on each channel for active scans * - * Range: 0 - 65536 tu + * Range: u32 tu/1000 */ - u16 max_dwell_time_active; + u32 max_dwell_time_active; /* - * The maximum time to wait on each channel for passive scans + * The minimum time to wait on each channel for passive scans * - * Range: 0 - 65536 tu + * Range: u32 tu/1000 */ - u16 min_dwell_time_passive; + u32 min_dwell_time_passive; /* * The maximum time to wait on each channel for passive scans * - * Range: 0 - 65536 tu + * Range: u32 tu/1000 */ - u16 max_dwell_time_passive; + u32 max_dwell_time_passive; /* * Number of probe requests to transmit on each active scan channel @@ -1090,6 +1146,51 @@ struct conf_rf_settings { u8 tx_per_channel_power_compensation_5[CONF_TX_PWR_COMPENSATION_LEN_5]; }; +struct conf_ht_setting { + u16 tx_ba_win_size; + u16 inactivity_timeout; +}; + +struct conf_memory_settings { + /* Number of stations supported in IBSS mode */ + u8 num_stations; + + /* Number of ssid profiles used in IBSS mode */ + u8 ssid_profiles; + + /* Number of memory buffers allocated to rx pool */ + u8 rx_block_num; + + /* Minimum number of blocks allocated to tx pool */ + u8 tx_min_block_num; + + /* Disable/Enable dynamic memory */ + u8 dynamic_memory; + + /* + * Minimum required free tx memory blocks in order to assure optimum + * performence + * + * Range: 0-120 + */ + u8 min_req_tx_blocks; + + /* + * Minimum required free rx memory blocks in order to assure optimum + * performence + * + * Range: 0-120 + */ + u8 min_req_rx_blocks; + + /* + * Minimum number of mem blocks (free+used) guaranteed for TX + * + * Range: 0-120 + */ + u8 tx_min; +}; + struct conf_drv_settings { struct conf_sg_settings sg; struct conf_rx_settings rx; @@ -1100,6 +1201,8 @@ struct conf_drv_settings { struct conf_roam_trigger_settings roam_trigger; struct conf_scan_settings scan; struct conf_rf_settings rf; + struct conf_ht_setting ht; + struct conf_memory_settings mem; }; #endif |