diff options
Diffstat (limited to 'include/linux/ssb/ssb.h')
| -rw-r--r-- | include/linux/ssb/ssb.h | 69 |
1 files changed, 60 insertions, 9 deletions
diff --git a/include/linux/ssb/ssb.h b/include/linux/ssb/ssb.h index 5ae8fa2..3d0a9ff 100644 --- a/include/linux/ssb/ssb.h +++ b/include/linux/ssb/ssb.h @@ -27,24 +27,54 @@ struct ssb_sprom { u8 et1mdcport; /* MDIO for enet1 */ u8 board_rev; /* Board revision number from SPROM. */ u8 country_code; /* Country Code */ - u8 ant_available_a; /* A-PHY antenna available bits (up to 4) */ - u8 ant_available_bg; /* B/G-PHY antenna available bits (up to 4) */ + u8 ant_available_a; /* 2GHz antenna available bits (up to 4) */ + u8 ant_available_bg; /* 5GHz antenna available bits (up to 4) */ u16 pa0b0; u16 pa0b1; u16 pa0b2; u16 pa1b0; u16 pa1b1; u16 pa1b2; + u16 pa1lob0; + u16 pa1lob1; + u16 pa1lob2; + u16 pa1hib0; + u16 pa1hib1; + u16 pa1hib2; u8 gpio0; /* GPIO pin 0 */ u8 gpio1; /* GPIO pin 1 */ u8 gpio2; /* GPIO pin 2 */ u8 gpio3; /* GPIO pin 3 */ - u16 maxpwr_a; /* A-PHY Amplifier Max Power (in dBm Q5.2) */ - u16 maxpwr_bg; /* B/G-PHY Amplifier Max Power (in dBm Q5.2) */ + u16 maxpwr_bg; /* 2.4GHz Amplifier Max Power (in dBm Q5.2) */ + u16 maxpwr_al; /* 5.2GHz Amplifier Max Power (in dBm Q5.2) */ + u16 maxpwr_a; /* 5.3GHz Amplifier Max Power (in dBm Q5.2) */ + u16 maxpwr_ah; /* 5.8GHz Amplifier Max Power (in dBm Q5.2) */ u8 itssi_a; /* Idle TSSI Target for A-PHY */ u8 itssi_bg; /* Idle TSSI Target for B/G-PHY */ - u16 boardflags_lo; /* Boardflags (low 16 bits) */ - u16 boardflags_hi; /* Boardflags (high 16 bits) */ + u8 tri2g; /* 2.4GHz TX isolation */ + u8 tri5gl; /* 5.2GHz TX isolation */ + u8 tri5g; /* 5.3GHz TX isolation */ + u8 tri5gh; /* 5.8GHz TX isolation */ + u8 rxpo2g; /* 2GHz RX power offset */ + u8 rxpo5g; /* 5GHz RX power offset */ + u8 rssisav2g; /* 2GHz RSSI params */ + u8 rssismc2g; + u8 rssismf2g; + u8 bxa2g; /* 2GHz BX arch */ + u8 rssisav5g; /* 5GHz RSSI params */ + u8 rssismc5g; + u8 rssismf5g; + u8 bxa5g; /* 5GHz BX arch */ + u16 cck2gpo; /* CCK power offset */ + u32 ofdm2gpo; /* 2.4GHz OFDM power offset */ + u32 ofdm5glpo; /* 5.2GHz OFDM power offset */ + u32 ofdm5gpo; /* 5.3GHz OFDM power offset */ + u32 ofdm5ghpo; /* 5.8GHz OFDM power offset */ + u16 boardflags_lo; /* Board flags (bits 0-15) */ + u16 boardflags_hi; /* Board flags (bits 16-31) */ + u16 boardflags2_lo; /* Board flags (bits 32-47) */ + u16 boardflags2_hi; /* Board flags (bits 48-63) */ + /* TODO store board flags in a single u64 */ /* Antenna gain values for up to 4 antennas * on each band. Values in dBm/4 (Q5.2). Negative gain means the @@ -58,7 +88,7 @@ struct ssb_sprom { } ghz5; /* 5GHz band */ } antenna_gain; - /* TODO - add any parameters needed from rev 2, 3, or 4 SPROMs */ + /* TODO - add any parameters needed from rev 2, 3, 4, 5 or 8 SPROMs */ }; /* Information about the PCB the circuitry is soldered on. */ @@ -208,6 +238,7 @@ enum ssb_bustype { SSB_BUSTYPE_SSB, /* This SSB bus is the system bus */ SSB_BUSTYPE_PCI, /* SSB is connected to PCI bus */ SSB_BUSTYPE_PCMCIA, /* SSB is connected to PCMCIA bus */ + SSB_BUSTYPE_SDIO, /* SSB is connected to SDIO bus */ }; /* board_vendor */ @@ -240,8 +271,12 @@ struct ssb_bus { /* The core in the basic address register window. (PCI bus only) */ struct ssb_device *mapped_device; - /* Currently mapped PCMCIA segment. (bustype == SSB_BUSTYPE_PCMCIA only) */ - u8 mapped_pcmcia_seg; + union { + /* Currently mapped PCMCIA segment. (bustype == SSB_BUSTYPE_PCMCIA only) */ + u8 mapped_pcmcia_seg; + /* Current SSB base address window for SDIO. */ + u32 sdio_sbaddr; + }; /* Lock for core and segment switching. * On PCMCIA-host busses this is used to protect the whole MMIO access. */ spinlock_t bar_lock; @@ -252,6 +287,11 @@ struct ssb_bus { struct pci_dev *host_pci; /* Pointer to the PCMCIA device (only if bustype == SSB_BUSTYPE_PCMCIA). */ struct pcmcia_device *host_pcmcia; + /* Pointer to the SDIO device (only if bustype == SSB_BUSTYPE_SDIO). */ + struct sdio_func *host_sdio; + + /* See enum ssb_quirks */ + unsigned int quirks; #ifdef CONFIG_SSB_SPROM /* Mutex to protect the SPROM writing. */ @@ -306,6 +346,11 @@ struct ssb_bus { #endif /* DEBUG */ }; +enum ssb_quirks { + /* SDIO connected card requires performing a read after writing a 32-bit value */ + SSB_QUIRK_SDIO_READ_AFTER_WRITE32 = (1 << 0), +}; + /* The initialization-invariants. */ struct ssb_init_invariants { /* Versioning information about the PCB. */ @@ -336,6 +381,12 @@ extern int ssb_bus_pcmciabus_register(struct ssb_bus *bus, struct pcmcia_device *pcmcia_dev, unsigned long baseaddr); #endif /* CONFIG_SSB_PCMCIAHOST */ +#ifdef CONFIG_SSB_SDIOHOST +extern int ssb_bus_sdiobus_register(struct ssb_bus *bus, + struct sdio_func *sdio_func, + unsigned int quirks); +#endif /* CONFIG_SSB_SDIOHOST */ + extern void ssb_bus_unregister(struct ssb_bus *bus); |