From d250a4810402ec68f64802b66340a0e70c61cbd3 Mon Sep 17 00:00:00 2001 From: Daniel Ritz Date: Mon, 6 Mar 2006 17:37:04 +0100 Subject: [PATCH] yenta: do power-up only after socket is configured Power-up the card only after the socket is configured. power-down in the old place. The point is not to power-up the card before the interrupt routing is set up correctly. Signed-off-by: Daniel Ritz Signed-off-by: Dominik Brodowski --- drivers/pcmcia/yenta_socket.c | 9 ++++++++- 1 file changed, 8 insertions(+), 1 deletion(-) (limited to 'drivers/pcmcia/yenta_socket.c') diff --git a/drivers/pcmcia/yenta_socket.c b/drivers/pcmcia/yenta_socket.c index 4145eb8..006749d 100644 --- a/drivers/pcmcia/yenta_socket.c +++ b/drivers/pcmcia/yenta_socket.c @@ -287,7 +287,10 @@ static int yenta_set_socket(struct pcmcia_socket *sock, socket_state_t *state) struct yenta_socket *socket = container_of(sock, struct yenta_socket, socket); u16 bridge; - yenta_set_power(socket, state); + /* if powering down: do it immediately */ + if (state->Vcc == 0) + yenta_set_power(socket, state); + socket->io_irq = state->io_irq; bridge = config_readw(socket, CB_BRIDGE_CONTROL) & ~(CB_BRIDGE_CRST | CB_BRIDGE_INTR); if (cb_readl(socket, CB_SOCKET_STATE) & CB_CBCARD) { @@ -339,6 +342,10 @@ static int yenta_set_socket(struct pcmcia_socket *sock, socket_state_t *state) /* Socket event mask: get card insert/remove events.. */ cb_writel(socket, CB_SOCKET_EVENT, -1); cb_writel(socket, CB_SOCKET_MASK, CB_CDMASK); + + /* if powering up: do it as the last step when the socket is configured */ + if (state->Vcc != 0) + yenta_set_power(socket, state); return 0; } -- cgit v1.1