From 8e23fcc89c8091790903927449f8efb9b4e23960 Mon Sep 17 00:00:00 2001 From: David Daney Date: Fri, 2 Jan 2009 13:49:54 +0000 Subject: Serial: Allow port type to be specified when calling serial8250_register_port. Add flag value UPF_FIXED_TYPE which specifies that the UART type is known and should not be probed. For this case the UARTs properties are just copied out of the uart_config entry. This allows us to keep SOC specific 8250 probe code out of 8250.c. In this case we know the serial hardware will not be changing as it is on the same silicon as the CPU, and we can specify it with certainty in the board/cpu setup code. The alternative is to load up 8250.c with a bunch of OCTEON specific special cases in the probing code. Signed-off-by: David Daney Signed-off-by: Andrew Morton Signed-off-by: Alan Cox Signed-off-by: Linus Torvalds --- drivers/serial/8250.c | 9 +++++++++ drivers/serial/serial_core.c | 7 +++++-- 2 files changed, 14 insertions(+), 2 deletions(-) (limited to 'drivers/serial') diff --git a/drivers/serial/8250.c b/drivers/serial/8250.c index 849af9d..3ae4974 100644 --- a/drivers/serial/8250.c +++ b/drivers/serial/8250.c @@ -2903,6 +2903,7 @@ static int __devinit serial8250_probe(struct platform_device *dev) port.mapbase = p->mapbase; port.hub6 = p->hub6; port.private_data = p->private_data; + port.type = p->type; port.serial_in = p->serial_in; port.serial_out = p->serial_out; port.dev = &dev->dev; @@ -3058,6 +3059,14 @@ int serial8250_register_port(struct uart_port *port) uart->port.private_data = port->private_data; if (port->dev) uart->port.dev = port->dev; + + if (port->flags & UPF_FIXED_TYPE) { + uart->port.type = port->type; + uart->port.fifosize = uart_config[port->type].fifo_size; + uart->capabilities = uart_config[port->type].flags; + uart->tx_loadsz = uart_config[port->type].tx_loadsz; + } + set_io_from_upio(&uart->port); /* Possibly override default I/O functions. */ if (port->serial_in) diff --git a/drivers/serial/serial_core.c b/drivers/serial/serial_core.c index 9425ed6..dc68b7e 100644 --- a/drivers/serial/serial_core.c +++ b/drivers/serial/serial_core.c @@ -2179,11 +2179,14 @@ uart_configure_port(struct uart_driver *drv, struct uart_state *state, * Now do the auto configuration stuff. Note that config_port * is expected to claim the resources and map the port for us. */ - flags = UART_CONFIG_TYPE; + flags = 0; if (port->flags & UPF_AUTO_IRQ) flags |= UART_CONFIG_IRQ; if (port->flags & UPF_BOOT_AUTOCONF) { - port->type = PORT_UNKNOWN; + if (!(port->flags & UPF_FIXED_TYPE)) { + port->type = PORT_UNKNOWN; + flags |= UART_CONFIG_TYPE; + } port->ops->config_port(port, flags); } -- cgit v1.1