From f580d511e9fd963d75464de030c3b8de5715ee09 Mon Sep 17 00:00:00 2001 From: Linus Walleij Date: Wed, 26 Sep 2012 17:21:36 +0200 Subject: serial: pl011: handle corruption at high clock speeds commit c5dd553b9fd069892c9e2de734f4f604e280fa7a upstream. This works around a few glitches in the ST version of the PL011 serial driver when using very high baud rates, as we do in the Ux500: 3, 3.25, 4 and 4.05 Mbps. Problem Observed/rootcause: When using high baud-rates, and the baudrate*8 is getting close to the provided clock frequency (so a division factor close to 1), when using bursts of characters (so they are abutted), then it seems as if there is not enough time to detect the beginning of the start-bit which is a timing reference for the entire character, and thus the sampling moment of character bits is moving towards the end of each bit, instead of the middle. Fix: Increase slightly the RX baud rate of the UART above the theoretical baudrate by 5%. This will definitely give more margin time to the UART_RX to correctly sample the data at the middle of the bit period. Also fix the ages old copy-paste error in the very stressed comment, it's referencing the registers used in the PL010 driver rather than the PL011 ones. Signed-off-by: Guillaume Jaunet Signed-off-by: Christophe Arnal Signed-off-by: Matthias Locher Signed-off-by: Rajanikanth HV Cc: Bibek Basu Cc: Par-Gunnar Hjalmdahl Signed-off-by: Linus Walleij Signed-off-by: Greg Kroah-Hartman --- drivers/tty/serial/amba-pl011.c | 15 ++++++++++++++- 1 file changed, 14 insertions(+), 1 deletion(-) (limited to 'drivers/tty') diff --git a/drivers/tty/serial/amba-pl011.c b/drivers/tty/serial/amba-pl011.c index 21dc4b7..7cbb367 100644 --- a/drivers/tty/serial/amba-pl011.c +++ b/drivers/tty/serial/amba-pl011.c @@ -1620,13 +1620,26 @@ pl011_set_termios(struct uart_port *port, struct ktermios *termios, old_cr &= ~ST_UART011_CR_OVSFACT; } + /* + * Workaround for the ST Micro oversampling variants to + * increase the bitrate slightly, by lowering the divisor, + * to avoid delayed sampling of start bit at high speeds, + * else we see data corruption. + */ + if (uap->vendor->oversampling) { + if ((baud >= 3000000) && (baud < 3250000) && (quot > 1)) + quot -= 1; + else if ((baud > 3250000) && (quot > 2)) + quot -= 2; + } /* Set baud rate */ writew(quot & 0x3f, port->membase + UART011_FBRD); writew(quot >> 6, port->membase + UART011_IBRD); /* * ----------v----------v----------v----------v----- - * NOTE: MUST BE WRITTEN AFTER UARTLCR_M & UARTLCR_L + * NOTE: lcrh_tx and lcrh_rx MUST BE WRITTEN AFTER + * UART011_FBRD & UART011_IBRD. * ----------^----------^----------^----------^----- */ writew(lcr_h, port->membase + uap->lcrh_rx); -- cgit v1.1