From 81d3f905389e22bb9a5176b9309c3f451c260e1a Mon Sep 17 00:00:00 2001 From: Inaky Perez-Gonzalez Date: Sat, 3 Oct 2009 16:51:02 +0900 Subject: wimax: allow WIMAX_RF_QUERY calls when state is still uninitialized Until now, calls to wimax_rfkill() will be blocked until the device is at least past the WIMAX_ST_UNINITIALIZED state, return -ENOMEDIUM when the device is in the WIMAX_ST_DOWN state. In parallel, wimax-tools would issue a wimax_rfkill(WIMAX_RF_QUERY) call right after opening a handle with wimaxll_open() as means to verify if the interface is really a WiMAX interface [newer kernel version will have a call specifically for this]. The combination of these two facts is that in some cases, before the driver has finalized initializing its device's firmware, a wimaxll_open() call would fail, when it should not. Thus, change the wimax_rfkill() code to allow queries when the device is in WIMAX_ST_UNINITIALIZED state. Signed-off-by: Inaky Perez-Gonzalez --- net/wimax/op-rfkill.c | 9 ++++++++- 1 file changed, 8 insertions(+), 1 deletion(-) (limited to 'net/wimax') diff --git a/net/wimax/op-rfkill.c b/net/wimax/op-rfkill.c index 40e1210..94d339c 100644 --- a/net/wimax/op-rfkill.c +++ b/net/wimax/op-rfkill.c @@ -305,8 +305,15 @@ int wimax_rfkill(struct wimax_dev *wimax_dev, enum wimax_rf_state state) d_fnstart(3, dev, "(wimax_dev %p state %u)\n", wimax_dev, state); mutex_lock(&wimax_dev->mutex); result = wimax_dev_is_ready(wimax_dev); - if (result < 0) + if (result < 0) { + /* While initializing, < 1.4.3 wimax-tools versions use + * this call to check if the device is a valid WiMAX + * device; so we allow it to proceed always, + * considering the radios are all off. */ + if (result == -ENOMEDIUM && state == WIMAX_RF_QUERY) + result = WIMAX_RF_OFF << 1 | WIMAX_RF_OFF; goto error_not_ready; + } switch (state) { case WIMAX_RF_ON: case WIMAX_RF_OFF: -- cgit v1.1