diff options
Diffstat (limited to 'include/linux')
| -rw-r--r-- | include/linux/percpu.h | 35 |
1 files changed, 12 insertions, 23 deletions
diff --git a/include/linux/percpu.h b/include/linux/percpu.h index 8ff1515..54a968b 100644 --- a/include/linux/percpu.h +++ b/include/linux/percpu.h @@ -85,31 +85,20 @@ /* * PERCPU_DYNAMIC_RESERVE indicates the amount of free area to piggy - * back on the first chunk if arch is manually allocating and mapping - * it for faster access (as a part of large page mapping for example). - * Note that dynamic percpu allocator covers both static and dynamic - * areas, so these values are bigger than PERCPU_MODULE_RESERVE. + * back on the first chunk for dynamic percpu allocation if arch is + * manually allocating and mapping it for faster access (as a part of + * large page mapping for example). * - * On typical configuration with modules, the following values leave - * about 8k of free space on the first chunk after boot on both x86_32 - * and 64 when module support is enabled. When module support is - * disabled, it's much tighter. + * The following values give between one and two pages of free space + * after typical minimal boot (2-way SMP, single disk and NIC) with + * both defconfig and a distro config on x86_64 and 32. More + * intelligent way to determine this would be nice. */ -#ifndef PERCPU_DYNAMIC_RESERVE -# if BITS_PER_LONG > 32 -# ifdef CONFIG_MODULES -# define PERCPU_DYNAMIC_RESERVE (24 << 10) -# else -# define PERCPU_DYNAMIC_RESERVE (16 << 10) -# endif -# else -# ifdef CONFIG_MODULES -# define PERCPU_DYNAMIC_RESERVE (16 << 10) -# else -# define PERCPU_DYNAMIC_RESERVE (8 << 10) -# endif -# endif -#endif /* PERCPU_DYNAMIC_RESERVE */ +#if BITS_PER_LONG > 32 +#define PERCPU_DYNAMIC_RESERVE (20 << 10) +#else +#define PERCPU_DYNAMIC_RESERVE (12 << 10) +#endif extern void *pcpu_base_addr; |